How modern Hall probes work
Magnetic measurement for dummies
A modern Hall element consists of a very thin slab of semiconducting material. If a current is injected parallel to the plate, a perpendicular magnetic field will drive the conductors to the left or right, thus causing a voltage differential between the left and right edges. This process is very nearly instantaneous; one can vary the sensitivity by varying the current; one can measure both positive and negative field components; and it is a simple affair to integrate such a sensor into a fully electronic measurement system.
The fine print: not suitable for dummies after all
This idyllic picture is disturbed by a number of annoying physical effects:
• A Hall element typically generates a voltage offset at zero field.
• The sensor response is only approximately linear.
• As the temperature increases, more conductors are available, and the device sensitivity changes.
• Hall plates also age, causing a long-term sensitivity drift.
• The planar Hall effect, whereby a field in the plane of the Hall plate creates a response, causes cross-talk between the vector components of the field.
• To the extent that the leads form current loops, moving a Hall probe in a strong field induces a voltage and biases the measurement.
• At cryogenic temperatures and with strong fields, the Hall conductivity becomes quantized.
… and more calibration
If the response is significantly non-linear, a calibration at one or more intermediate field values is required. If the instrument has several sensitivity ranges, it should be calibrated at every range. To compensate for temperature effects, the entire calibration needs to be repeated at at least two temperatures. And if one wants to compensate for the planar Hall effect or other sources of cross-talk, a very complicated 3D calibration and de-convolution becomes necessary.
The uncontrolled error source
One source of error escapes the best sensor technology and calibration procedure: angular positioning. Even the best measurement laboratories are obliged to send the Hall sensor on a harrowing journey from calibration jig to measurement jig, with nasty gangs of rolls, pitches and twists just waiting to cumulate at every move. The situation is of course infinitely worse for a handheld device. It is for this reason that Metrolab advocates using three-axis sensors that minimize the loss of information.
MagVector™ MV2 磁力計素子
HMC9076 ホール マグネティック フィールドカメラ
General science & engineering
Fringe field measurement
Magnetic background monitoring
Want to know more ?
Contact us for more information !